Spring Post
 

Autosign Industries’s Safety Cones are made of special Pliant material, it can quickly restore to its original state without damaging the vehicle and itself in case of a high-speed collision.

Highly reflective heat transfer sheet is pasted on specially designed grooves, make it highly visible from distance at night or in bad weather.

Its tensile strength and UV stabilizers enables it withstand the harshest of weather conditions. It is easy to install with a epoxy and other strong adhesives without damage to roads or bridges.

 
« Model No. AISP - 01
DIMENSION
A - 80mm DIA
B - 80mm
C - 710mm
D - 200mm DIA
E - 308mm
 
Model No. AISP - 02 »
DIMENSION
A - 80.00 mm DIA
B - 50mm
C - 300mm
D - 200.00mm DIA
E - WEIGHT:- 580 grm
 
« Model No. AISP - 03
DIMENSION
A - 77.00mm DIA
B - 50.00mm
C - 600.00mm
D - 200.00mm DIA
E - WEIGHT :- 970 grm
 
Model No. AISP - 04 »
DIMENSION
A - 77 MM DIA
B - 80 MM
C - 975 mm
D - 200 MM
E - 440 MM DIA
Weight: 2300 gm
 

Usage Areas:

  • Center Lane Dividing for narrow roads
  • Multi lanes for broad roads
  • Sharp Curves
  • Traffic Islands
  • At the start of central verge (where single road becomes double road)
  • No Stop Zone at T Shape road traffic signals
  • Parking lots
  • Construction Zones
  • No Entry Zone
  • Dangerous medians and 'U' Turn etc.

Usage Installation Procedure:

Clean the area where spring post is to be installed. Mark the nail points, grout the holes and clean the surface again. Pour some good quality of epoxy then place the spring post and fix the bolts with hammer.

 
About Autosign
 
Services
 
Contact Us
 
 
© Copyright 2011 : www.autosignindustries.com All right's Reserved by Autosignindustries
Powered by :